Comments on: Rust Bullet’s New No Etch DuraGrade Floor Coating is on Target

By: Lloyd Baird

Lloyd Baird — Tue, 30 Dec 2025 11:24:17 +0000

In reply to Shea Walker. Thanks for the Information, It will help me decide how to proceed in the future.

By: Shea Walker

Shea Walker — Tue, 30 Dec 2025 01:51:20 +0000

In reply to Lloyd Baird. Hi Lloyd. It will require a thorough degreasing to remove the oil and gas residue. Otherwise, it will block proper adhesion. Make sure the concrete is completely dry (not just the surface) before applying. You can find their application instructions here.

By: Lloyd Baird

Lloyd Baird — Mon, 29 Dec 2025 23:23:37 +0000

What type of preparations would be required for a 20 year old garage floor that has oil and gasoline stains ??

By: Shea Walker

Shea Walker — Wed, 19 Mar 2025 00:11:44 +0000

In reply to matt jones. You would need to remove the TS210 via grinding before applying any other coating.

By: matt jones

matt jones — Tue, 18 Mar 2025 23:57:31 +0000

In reply to Shea Walker. Also, I read the article on the TS210. Can you ever epoxy or coat over the TS210 later or would it need to be ground first and would grinding be sufficient if later using another coating. thanks!

By: Shea Walker

Shea Walker — Tue, 18 Mar 2025 23:53:46 +0000

In reply to Matt Jones. The etch will be sufficient. Just follow the directions and make sure it dwells long enough on the surface. Norh-S is solvent-based, so it has good penetration qualities once the surface is opened up a bit.